1. Dust removal before filling
The honeycomb activated carbon needs to be dedusted before filling to remove the activated carbon and dust damaged during transportation, so as to avoid the adsorption of effective activated carbon.
2. The use of general honeycomb activated carbon is strictly prohibited
Because if the activated carbon will scatter after wetting, if the application is relatively wet, it is advisable to use water-resistant honeycomb activated carbon.
3. The high temperature of honeycomb activated carbon shall be controlled as much as possible
Because high temperature will reduce the adsorption capacity, and the adsorption effect will be reduced due to the increase of temperature.
4. It is necessary to stop the dust mist in the tar
At the same time, it is necessary to prevent the dust mist in the tar, which will hinder the pores of the activated carbon, increase the wind resistance and reduce the adsorption effect. In this case, the honeycomb activated carbon must be installed in front of the filter dust removal device in order to improve the service life and service capacity.
5. Honeycomb activated carbon needs to be replaced after adsorption saturation
Because the place of use is not common, the service cycle is not fixed. It is recommended to replace it every 6-12 months.
